Monday, December 25, 2017

To configure the local loop back adapter in vmware

To install the Loopback adapter:

Click Start > Control Panel > Add Hardware.
Click Next on the introduction dialog box.
Select Yes, I have already connected the hardware and click Next.
Select Add a new hardware device, and click Next.
Select Install the hardware that I manually select from a list (Advanced), and click Next.
Select Network adapters, and click Next.
Select Microsoft as the manufacturer, select Microsoft Loopback Adapter as the adapter, and click Next.
Click Next to confirm the installation.
Click Finish to complete the installation.

To configure the newly created adapter:

Click Start > Control Panel > Network Connections.
Select the newly created connection (named Local Area Connection #, where # is its order number).
Right-click on the selected connection and choose Properties from the menu.
Confirm that Microsoft Loopback Adapter or Microsoft Loopback Adapter # is displayed in the Connect Using: field. If it is not, return to step 2 and retry properties for another adapter.
Deselect everything except Internet Protocol (TCP/IP).
Select Internet Protocol (TCP/IP), and click Properties to open Internet Protocol (TCP/IP) Properties.
Select Use the following IP address:. Fill in the IP address: and Subnet mask: fields. For example,,
Click Advanced to open Advanced TCP/IP Settings.
Switch to WINS and select Disable NetBIOS over TCP/IP.
Click OK to close Advanced TCP/IP Settings.
Click OK to close the Internet Protocol (TCP/IP) Properties.
In Windows XP only, Deselect Notify me when this connection has limited or no connectivity to remove the connection warning icon from the system notification area.
Click OK to close the connection properties.

No comments:

Post a Comment

Hope You are having a good time reading My Blog